Advertisement
13-1/4"
(337 mm)
Min
18-1/4"
(464 mm)
Min
19-3/4"
(502 mm)
Max
17-11/16" (449 mm)
Required Electrical Service
One dedicated circuit required, protected with Class A Ground-
Fault Circuit-Interrupter (GFCI). Outside North America, this
device may be known as a Residual Current Device (RCD).
120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
Seat shape type:
Elongated
Seat front type:
Closed-front
Seat-mounting
5-1/2" (140 mm)
holes:
Power cord length:
39" (991 mm)
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.NovitaSeats.com.
8-13-2023 02:28 - US/CA
5-1/2"
(140 mm)
1-1/4"
(32 mm)
Min
7-7/8"
(200 mm)
11-7/8"
(302 mm)
15-1/4" (387 mm)
5" (127 mm)
20-7/8"
(530 mm)
16-3/8"
(416 mm)
1-9/16"
(40 mm)
Notes
Install this product according to the installation
instructions.
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi -
80 psi (139 kPa - 551 kPa).
Do not install this seat in a location where: (1)
water might be splashed on the product or
(2) excessive moisture, high humidity levels,
or condensation is present. This will avoid
damage to the electronic components.
NOTICE: Do not use an extension cord with
this product.
NOTICE: Do not plug in the seat until instructed
to do so in the installation guide. This will avoid
possible product malfunction.
Locate the receptacle at least 6" (152 mm)
above the floor, and within a 32" (813 mm)
radius measured 2" (51 mm) from the bowl
ledge.
BN330
Elongated bidet toilet seat
32" (813 mm) R.
2"
(51 mm)
6" (152 mm) Min
Electrical Service Detail
BN330
Advertisement
