Connect The Trigger Output; Connect To Ac Power - Harman Kardon AVR 370 Service Manual

AVR
to control more than one source device through the Avr's Ir remote out connector,
connect all sources in "daisy chain" fashion, connecting each device's Ir output to the
next device's Ir input, starting with the Avr.
• If you install a multizone system, connect an Ir control device to the Zone 2 Ir In
connector for remote-room control of the multizone system, source devices and
volume in the remote zone.
external Ir receiver
If a source device is shared with the main listening area, any control commands issued
to that source will also affect the main room.

Connect the Trigger Output

If your system has equipment that can be controlled by a dc trigger signal, connect it to
the Avr's trigger out connector with a mono 1/8-inch (3.5mm) mini-plug interconnect
cable. the Avr will supply a 12v dc (100mA) trigger signal at this connection whenever
it is powered on.
mono 1/8-inch
(3.5mm) mini-plug
Interconnect
(not supplied)
Zone 2 Speakers
Zone 2
Main Room
Avr
Avr
device with
trigger In connector

Connect to AC Power

connect the supplied Ac power cord to the Avr's Ac Input connector and then to a
working Ac power outlet.
Avr
Ac Input
connector
power cord (supplied)
Making Connections,
Ac power
outlet
23