Connect To Your Home Network; Connect The Radio Antennas; Install A Multizone System - Harman Kardon AVR 370 Service Manual

AVR

Connect to Your Home Network

use a cat. 5 or cat. 5e cable (not supplied) to connect the Avr's network connector to
your home network to enjoy Internet radio and content from dlnA-compatible devices
that are connected to the network.
Avr
network
connector
cat. 5/5e ethernet cable
(not supplied)
AVR 3700/AVR 370 only:
If your home network is wi-fi ® , attach the supplied wi-fi antenna to the Avr. you do not
need to make a wired network connection.

Connect the Radio Antennas

• connect the supplied fm antenna to the Avr's fm 75Ω antenna connector. for the
best reception, extend the fm antenna as far as possible.
• bend and fold the base of the supplied Am antenna as shown and connect the
antenna wires to the Avr's Am and gnd connectors. (you can connect either wire to
either connector.) rotate the antenna as necessary to minimize background noise.
Am Antenna
(supplied)
Avr
Antenna
connectors
fm Antenna (supplied)

Install a Multizone System

network
modem
NOTE: only the following analog audio sources are available to Zone 2: the internal radio,
an ipod/iphone device or a uSb memory device inserted in the Avr's uSb port and up
to two source devices connected to the rear-panel Analog Audio In 1 and 2 connectors.
to home
your Avr offers two different methods of distributing audio to other areas in your home.
network
each requires different connections:
and Internet
A. Connect the Zone 2 speakers directly to the Assigned Amp Speaker Output
connectors. Assign the Assigned Amp channels to power the Zone 2 speakers (see
Manual Speaker Setup, on page 36). this method allows you to power a single pair of
speakers for Zone 2.
this method offers the benefit of reduced cost and complexity, but your home theater
system will be limited to 5.1 channels – the Avr will automatically downmix the playback
of programs recorded in 6.1 or 7.1 channels to 5.1 channels.
bend and fold base
IMPORTANT SAFETY NOTE: Installing a multizone system typically requires
running cables inside walls. Always comply with the appropriate safety codes
when installing concealed wiring, particularly all applicable building codes.
Failure to do so may present a safety hazard. If you have any doubt about
your ability to work with electrical wiring, hire a licensed electrician or custom
installer to install the multizone system.
Zone 2
Speakers
Assigned
Amp
Speaker
connectors
Speaker wire
(not supplied)
Avr
fl
5.1-channel
home theater
Speaker System
Sl
Making Connections
Zone 2
Main Room
Speaker wire
(not supplied)
c
fr lfe
Sr
21