Table of Contents
Advertisement
Clean the smooth enamel surfaces in the cooking
3.
compartment with a dish cloth or a soft brush. Re-
move stubborn food remnants using a stainless
steel scouring pad.
4.
Remove limescale with a cloth soaked in vinegar,
and wipe this away with clean water.
21 Drying function
To prevent residual moisture, dry the cooking compart-
ment following microwave-only operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
21.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying function" function.
Allow the appliance to cool down.
1.
Remove dirt from the cooking compartment.
2.
Wipe away the water in the cooking compartment.
3.
Dry the cooking compartment.
4.
To dry the cooking compartment, leave the appli-
‒
ance door open for 1 hour.
22 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
22.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
Open the appliance door slightly.
1.
Press down on the left- and right-hand sides of the
2.
door cover
.
Remove the door cover
3.
appliance door.
and carefully close the
Dry the cooking compartment with a soft cloth.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for approx. 1 hour or use
the "Drying" function.
→ "Setting the drying process", Page 27
To use the "Drying function" function, set "Drying
‒
function".
→ "Setting the drying process", Page 27
Setting the drying process
Requirement: → "Drying the cooking compartment",
Page 27
Press "Cleaning".
1.
Press "Drying function".
2.
The duration cannot be changed.
Press
.
3.
a A notification stating that you should carry out the
necessary preparatory work for the drying appears
on the display.
Confirm the notification.
4.
a The drying process starts and the duration counts
down.
a Once the drying has ended, a signal tone sounds. A
notification appears on the display confirming that
the operation has finished.
Press
to switch the appliance off.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for 1 to 2 minutes.
22.2 Removing the door panes
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or sharp
▶
metal scrapers to clean the glass on the oven door,
as they may scratch the surface.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
Requirement: The door cover has been removed.
→ "Removing the door cover", Page 27
Undo and remove the screws
1.
of the appliance door.
Place a folded-up tea towel in the appliance door.
2.
Close the appliance door.
3.
Drying function en
on the left and right
27
Advertisement
Chapters
Table of Contents
