Advertisement
IMPORTANT: To change from Minutes and Seconds
M:S to Hours and Minutes H:M. Press and hold the
SCAN/UP Button. When the display reaches 59:59 it
will automatically change to 1:00 Hour and the LED will
switch from M:S to H:M. The program value for the
H:M indicator is from 1:00 hour to 17 hours: 59 min-
utes. See figures 3 and 4.
Figure 3
Figure 4
4. Press the desired channel button to program
another channel. Repeat programming procedures
in steps 2 and 3 above.
5. When finished programming each desired channel,
momentarily press the PRINCE CASTLE logo to
end the Program Mode. This saves the program
changes you have made for all channels.
See figure 5.
740-520revA
59:59
1:00
Figure 5
6. You can change the sound level of the alarm in
RUN MODE. Press and hold the PRINCE CASTLE
logo; then, within six seconds, press either the
SCAN UP Arrow button or the SCAN DOWN Arrow
button. The SCAN UP Arrow button adjusts the
sound level to the louder alarm, the SCAN DOWN
Arrow button adjusts the sound level to the lower
alarm.
OPERATION
1. Press a channel button to activate a timing cycle.
(All channels can be activated and running at the
same time.) The time remaining will countdown in
the TIME display, and the time value M:S or H:M will
be illuminated. See figure 6
Figure 6
2. Press the desired channel button three times within
five seconds to cancel an active timing cycle.
3
2:59
Printed in USA 3/06 © 2006
Advertisement
