Sony SS-MF600H, SS-MF500H, SS-MF400H - Speaker System Manual

Also See for SS-MF600H:

Table of Contents

Connections

Before connection, turn off the amplifier to avoid damaging the speaker system.
This speaker system is driven best by an amplifier or receiver rated as per the wattage indicated in the specification section. A low-powered amplifier could result in signal clipping which could result in tweeter burn-out. Therefore, it is recommended to use an amplifier or receiver with sufficient power rating.

Standard Connection
Note
Avoid driving the speaker system continuously with a wattage exceeding the maximum input power of each speaker.

Do not attempt to open the enclosure or remove speaker units. There are no user-serviceable parts inside.
Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the speaker system.
Periodically wipe the cabinet with a soft cloth. Do not use any type of scouring powder, abrasive pad or solvent.
Be sure to install the grill net in the correct direction.

Please note that room acoustics can often produce large difference in the sound for small changes in speaker placement.

Set up your speaker system on a hard, flat floor.
Place the speaker system against a hard wall with its back about 10 cm away from a wall. The proportion of bass increases as you move a speaker close to intersecting room surfaces (wall and wall, etc.).
Place the right and left speakers in a similar acoustic environment.
It is recommended that the speaker/listener relationship be an equilateral triangle.

SS-MF600H

Speaker system	3-way, magnetically shielded
Loud speaker units	Woofer: 20 cm, cone type × 2 Mid range: 8 cm, cone type Tweeter: 2.5 cm, balance dome type
Enclosure type	Bass reflex
Rated impedance	8 ohms
Power handling capacity	Maximum input power: 200 watts
Sensitivity level	89 dB (1 W, 1 m)
Frequency range	35 Hz - 50,000 Hz
Cross over frequency	2,000 Hz, 5,000 Hz
Dimensions (w/h/d)	Approx. 240 × 1,050 × 272 mm, not including front grille
Finish	Black foil laminated
Mass	Approx. 15 kg
Supplied accessory	Speaker cord 2.5 m (2)

SS-MF500H

Speaker system	3-way, magnetically shielded
Loud speaker units	Woofer: 16 cm, cone type × 2 Mid range: 8 cm, cone type Tweeter: 2.5 cm, balance dome type
Enclosure type	Bass reflex
Rated impedance	8 ohms
Power handling capacity	Maximum input power: 180 watts
Sensitivity level	89 dB (1 W, 1 m)
Frequency range	40 Hz - 50,000 Hz
Cross over frequency	3,000 Hz
Dimensions (w/h/d)	Approx. 220 × 950 × 230 mm, not including front grille
Finish	Black foil laminated
Mass	Approx. 12 kg
Supplied accessory	Speaker cord 2.5 m (2)

SS-MF400H

Speaker system	3-way, magnetically shielded
Loud speaker units	Woofer: 16 cm, cone type Mid range: 8 cm, cone type Tweeter: 2.5 cm, balance dome type
Enclosure type	Bass reflex
Rated impedance	8 ohms
Power handling capacity	Maximum input power: 150 watts
Sensitivity level	88 dB (1 W, 1 m)
Frequency range	50 Hz - 50,000 Hz
Cross over frequency	2,000 Hz, 5,000 Hz
Dimensions (w/h/d)	Approx. 220 × 850 × 230 mm, not including front grille
Finish	Black foil laminated
Mass	Approx. 10 kg
Supplied accessory	Speaker cord 2.5 m (2)