Installation Instructions - Kangui JUMPI POP Installation Instructions & User Manual

2) INSTALLATION INSTRUCTIONS

The product must be assembled carefully by 2 adults. Before starting the assembly procedure, read the manual
carefully then follow these steps :
• Wear suitable clothing, shoes and gloves to avoid falls, pinching and cuts.
• Remove all the packaging materials and spread out the parts over an empty space. This will give you an
overview and simplify assembly. Check on the parts list that nothing is missing.
• Create a safe environment by making sure, for example, that no tools are left spread around the working area.
Store the packaging materials so that they do not cause any danger. Plastic bags are a hazard for children
(risk of suffocating).
• At least 8 m free space is required above the trampoline. At least 3 m free space is required between the
trampoline and any nearby structure, or any obstruction as barrier, garage, house, branches overhanging,
clotheslines or electrical wiring.
• This trampoline is not intended to be buried into the ground and not install near electric wires, tree branches
or other potential hazards.
• Do not install the trampoline when it is raining, when there are strong winds or a storm. You are recommended
to move the trampoline under shelter when the weather conditions are bad.
• The trampoline must always be installed in a well lit area.
• Make sure that the trampoline is correctly positioned on a horizontal surface. To check this: place a spring
on the logo in the centre of the mat and adjust the trampoline until the spring does not move and stays in the
centre of the mat.
• The trampoline must not be installed on concrete, asphalt or any hard coating, o nearby facilities incompatible
(for example wading pools, swings, slide, climbing structures) ; soft ground is best.
• If you need to move the assembled trampoline, 4 persons around the frame are required to lift it. When
repositioning, check that the trampoline legs and struts are correctly in place.
• Use of the protective pads is mandatory. Check that they are correctly fastened to the frame and that all the
springs are correctly positioned with the hook of the loop pointing downwards.
• Pay attention to overexposure of your trampoline to UV radiation: do not install it near a swimming pool, a bright
façade, etc. The protective pad and the net would age prematurely.
• Kangui recommends to insure that the trampoline is embedded in the ground with an anchor kit or weighted
with sand bags. In case of high winds or storm, ballasting is not in itself sufficient, it's critical to remove net,
pad and eventually jumping mat or any items catching wind and keep the trampoline protected from wind.
CAUTION! Fix the trampoline in the ground and do not jump when high wind.
• If a ladder is used, make sure it is designed for this particular use.
• Modifications made by the consumer to the original trampoline (i.e. the adding of an accessory) shall be carried
out according to the instructions of the manufacturer.
16