Connecting To Optional Equipment - Toshiba SD4010KB Owner's Manual

Content of the output for each output jack is shown in the following table and differ depending on the On-Screen Display
Setting:
On-Screen Display Setting
"Video" HDMI Output
Setting Setting
RGB Invalid
576p/480p
720p
HDMI
1080i
1080p
* Settings for HDMI output format are performed using the HDMI button on the remote control or HDMI SELECT button
on the front panel.
Note
• If Auto is selected, it follows preference HDMI aspect ratio of TV.

Connecting to Optional Equipment

You can enjoy high quality dynamic sounds by connecting the DVD player to optional audio equipment.
• For connection to your TV, see "Connecting to a TV" .
• This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal fl ow
Notes
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the AC-3 RF input of a Dolby Digital
Receiver. This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL
DIGITAL AUDIO OUT jack of the DVD player.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the "DIGITAL (COAXIAL)" input of a Receiver or
Processor.
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifi er before you connect or disconnect the DVD player's power cord. If you leave the amplifi er power on,
the speakers may be damaged.
Content of output for each output jack
HDMI Video
Output Output
- Composite
576p/480p Composite
720p Composite
1080i Composite
1080p Composite
AV
Output
RGB
Composite
Composite
Composite
Composite
Warning
• When you are connecting (via the COAXIAL DIGITAL
AUDIO OUT jack) an AV decoder that does not have
®
Dolby Digital, DTS or MPEG2 decoding function, be
sure to set "Digital out" to "PCM" from the on-screen
displays. Otherwise, high volume sound may damage
your hearing as well as the speakers.
• When playing DTS-encoded discs (DVDs and audio
CDs), excessive noise may be output from the analog
audio output jacks. To avoid possible damage to the
audio system, you should take proper precautions
when the analog audio output jacks of the DVD player
are connected to an amplifi cation system. To enjoy DTS
Digital Surround™ playback, an external 5.1 channel
DTS Digital Surround™ decoder system must be
connected to the COAXIAL DIGITAL AUDIO OUT jack
of the DVD player.
17