Table of Contents
Advertisement
7 Overview of applications
7.2
Vacuuming only
Jars with screw-top lids, containing e.g. nuts or kernels, can be vacuumed and sealed
airtight at the same time using this application.
Only use jars with intact screw-top lids. Check that the jars are not too tall before
closing the appliance lid.
Do not use the bag tray.
The jars may be max. 8.5 cm tall to avoid damage to the appliance.
This application is not suitable for making jam (filling with hot content). Only
chilled food should be vacuum sealed.
The vacuum drawer must be ready for operation.
▸ Lightly close the screw-top lids of the jars and place the jars in the vacuum tank.
▸ Touch the
button once or more to select a suitable vacuuming level.
▸ Touch the
button repeatedly until the display for the sealing time goes out com-
pletely.
▸ Press down the appliance lid and start the process with the
7.3
Sealing only
Using this application, a bag can be closed airtight without creating a vacuum.
Despite the setting, a slight underpressure is created in the bag, and this is neces-
sary to create a successful seal.
The vacuum drawer must be ready for operation.
▸ Touch the
button repeatedly until the display for the vacuuming level goes out com-
pletely.
▸ Touch the
button once or more to select a suitable level for the sealing time.
▸ Press down the appliance lid and start the process with the
7.4
External vacuuming
Using this application, air can be evacuated out of glass bottles of oil and wine, for in-
stance, to prevent the contents reacting with the oxygen. This function can also be used
to vacuum seal commercially available vacuum containers. Make sure that the vacuum
containers are safe for use with food and can be connected to the vacuum drawer tube,
which has a 3 mm internal diameter, using a suitable adapter.
For external vacuuming of glass bottles, only use bottles that are suitable for va-
cuum sealing. Unsuitable or damaged bottles could implode during external vacu-
uming. There is a risk of injury.
The vacuum drawer must be ready for operation and the lid open.
▸ To evacuate a bottle, push either end of the tube onto the right connector for each ad-
apter.
▸ Put the larger adapter on the suction inlet in the vacuum tank. To evacuate a bottle,
put the smaller adapter with the other end of the tube on the vacuum stopper, which
is pressed into the bottle mouth. To evacuate a vacuum container, connect the end of
the tube to the vacuum container – rather than to the bottle – using an adapter if ne-
cessary.
16
button.
button.
Advertisement
Table of Contents
