TaoTronics SOUNDSURGE 60 TT-BH060 - ANC Wireless Stereo Headphones Manual

Table of Contents

Product Diagram

Note:

A voice prompt will be heard when the battery is low.
Switch the ANC Button to activate / deactivate the noise cancellation function. Its indicator will turn on / off accordingly.

1 x TaoTronics Wireless ANC Headphones
1 x USB Charging Cable
1 x 3.5mm Audio Cable
1 x Travel Pouch
1 x User Guide

Connect the charging port with any USB charging adapter or active computer USB port.
Charging will start automatically with the LED indicator turning red.
The headphones are fully charged when the LED indicator turns off.

Make sure the headphones and your Bluetooth device are next to each other (within 3 feet / 1 meter).
Press and hold the Power Button for 5 seconds to bring the headphones into pairing mode with the LED indicator flashing blue and red.
Activate Bluetooth on your phone and search for nearby Bluetooth connections.
Find "TAOTRONICS SoundSurge 60" in the search results. Tap on the name to connect. Once connected, the LED indicator will flash blue once every 3 seconds.

Note:

The Bluetooth headphones can remember previously paired devices. If you have previously paired the headphones with a device, simply turn on your device and the headphones, they will connect automatically without going into pairing mode.
In case the headphones fail to pair with your Bluetooth device, clear the pairing history by pressing and holding the Power and Volume - Buttons simultaneously for 5 seconds until you hear a beep and the LED indicator flashes purple once.
Then it blinks red and blue alternately to start pairing again.

Function	Operation
Power on / off	Press and hold the Power Button until the LED indicator flashes / turns off
Play / Pause / Answer /Hang up phone calls	Press the Power Button once
Reject phone calls	Press and hold the Power Button for 2 seconds
Redial	Press the Power Button twice
Volume + / -	Press the Volume + / - Button
Previous / Next Track	Press and hold the Volume + / - Button