Table of Contents
Advertisement
3. Align the splines and insert the
propeller on the propeller shaft.
The propeller shaft must fit evenly on
the splines.
4. Wipe off excess grease.
Install the propeller shaft nut.
5. Place a block of wood between one of
the propeller blades and the hull.
Mount the special insert T2 on a
suitable torque wrench and insert into
the hole in the propeller nut and tighten
to a torque of 125 N·m.
6. Install the locking screw in the center.
Tighten the locking screw to a torque of
23 N·m.
SD60 Operation Manual
PERIODIC MAINTENANCE
Figure 19
Figure 20
Figure 21
Figure 22
050910-01X01
050914-01X00
T2
050915-01X00
050916-01X00
29
Advertisement
Table of Contents
