Troubleshooting - RedMax 970497502 Operator's Manual

To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your RedMax service
agent.
Problem
Engine does not start.
The starter motor does not turn
the engine over.
2180 - 001 - 22.06.2023
A
C
B

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
on page 4 .
Steering controls are not locked in the parking brake position.
The battery is too weak. Refer to
There is dirt in the fuel line.
The shut-off valve of fuel supply is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
The battery is too weak. Refer to
The connection at the cable connectors on the battery terminals is bad.
To clean the battery on page 18 .
Refer to
A fuse is blown. Refer to
The OPC does not operate correctly. Refer to
9 .
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
PTO (Power Take-Off) button
To charge the battery on page 19 .
To charge the battery on page 19 .
Fuses on page 5 .
Operation conditions on page
25