Troubleshooting - RedMax CZT60TX Operator's Manual

Idler arm bushing nut
Lug nuts
Blade bolts
Spark plug
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your RedMax service
agent.
Problem
Engine does not start.
The starter motor does not turn
the engine over.
The engine does not run
smoothly.
The engine apparently has no
power.
2062 - 001 - 08.02.2023
70 ft-lb / 95 Nm
75 ft-lb / 102 Nm
90 ft-lb / 122 Nm
16.6 ft-lb / 22.5 Nm

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
on page 4 .
Steering controls are not locked in the parking brake position.
The battery is too weak. Refer to
There is dirt in the fuel line.
The shut-off valve of fuel supply is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
The battery is too weak. Refer to
The connection at the cable connectors on the battery terminals is bad.
To clean the battery on page 18 .
Refer to
A fuse is blown. Refer to
The OPC is defective. Refer to
The fuel filter or fuel jet is clogged.
The check valve on the fuel tank cap is clogged.
The fuel tank is almost empty.
The spark plug is defective.
Incorrect fuel mix or fuel type.
There is water in the fuel.
The air filter is clogged.
The air filter is clogged.
The spark plug is defective.
There is air in the hydraulic system.
PTO (Power Take-Off) button
To charge the battery on page 18 .
To charge the battery on page 18 .
Fuses on page 5 .
Operation conditions on page 9 .
25