3-10 Installing the System into the Cabinet
Read the following guidelines before you begin to install the system into the cabinet:
• Make sure the system is not turned on or connected to AC power.
• A Lift Table is required. Place the system unit on Lift Table.
• Two Person lift required. Firmly hold the bottom of the system when required to lift and carry the
system.
• Failure to observe these warnings could result in personal injury or damage to the equipment.
Follow these instructions to install the system into the cabinet:
1.
Pull out and release the thumbnail screw securing the chassis handle in place.
2.
Remove the four handles on each side of the system.
3.
Carefully slide the system into the cabinet.
1
2
3
System Hardware Installation
2
- 38 -
2
2