Cleaning The Infuser - DeLonghi ESAM3500.S Manual

Hide thumbs Also See for ESAM3500.S:
Table of Contents

Advertisement

To unblock them, scrape the dry coffee residues away with a needle (fig. 27).
Clean the nozzle regularly with a sponge as shown in fig. 26.

15.2 Cleaning the infuser

The infuser must be cleaned regularly to avoid the build-up of coffee encrustations which could cause mal-
function. Proceed as follows:
• turn the appliance off by pressing the
• open the service door (Fig. 14);
• remove the drip tray and the grounds container (Fig. 15) and clean them;
• press the two red release buttons on the infuser sideways and towards the centre (Fig. 28) and pull it out;
• IMPORTANT: THE INFUSER CAN ONLY BE REMOVED IF THE APPLIANCE IS OFF.. ATTEMPTING TO
REMOVE THE INFUSER WITH THE APPLIANCE ON MAY CAUSE SERIOUS DAMAGE.
• wash the infuser under running water, without using detergents. Never wash the infuser in the dishwasher;
• carefully clean the inside of the appliance. To remove the coffee stuck to the parts inside the appliance,
scrape it with a plastic or wooden fork (Fig. 29) and then pick up all the residues using a vacuum clea-
ner (Fig. 30);
• replace the infuser by sli-
ding it onto the supports
and pin at the bottom,
then
push
the
symbol fully in until it clicks
into place.
The two red buttons have
snapped out CORRECTLY
Check that the two red buttons have snapped out, otherwise the door cannot be closed.
• replace the drip tray, complete with the grounds container;
• close the service door.
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-
ped out, the service door cannot be closed.
NOTE 2: if it is hard to insert the infuser, before inserting it, squeeze to size by pressing it vigorously from
above and below at the same time, as shown in Figure 31.
32
button (fig. 6) (do not unplug) and wait for the display to go off;
PUSH
Support
Pin
CORRECT
Infuser
Push the PUSH symbol fully in
until it clicks into place.
After having heard the click,
check that the red buttons have
snapped out.
Bottom pipe on the infuser.
The pin must be inserted into the bottom
pipe on the infuser.
The two red buttons have not
snapped out
INCORRECT

Advertisement

Table of Contents
loading

Table of Contents