Service Rest Button; Power Requirements - Beko DRYPOINT XCe 80 Installation And Operating Manual

Heatless regenerated dryer

Table of Contents

7.6

Service Reset Button

Disconnect dryer from power. With the dryer disconnected from the power source press the reset button

and hold it and plug the dryer back in to its power source. After that the timer is reset to 8000 hrs.

After 360-days of the service indicator LED will flash amber indicating that service is due, and after 400-

days the LED will flash red indicating that service is overdue.

7.7

The controller operates on 100-120VAC / 50-60Hz. The units are shipped with an installed standard US 120 volt cord

for convenience. Before starting up the machine it is necessary to have a qualified electrician review the electrical

requirements schematic and install to the National Electric Code. Please refer to Section 12.

The optional BEKOMAT® on the pre-filter at the dryer inlet is supplied according to the power voltage

indicated in the order; verify its compatibility with the information given on the type plate.

DRYPOINT® XC Series Heatless Regenerated Dryers: IOM10003

(Rev.I)

Table of Contents