Opening The Door; Closing The Door; Automatic Lock - BorMann BDS2500 Manual

OPENING THE SAFE WITH THE EMERGENCY KEY
• To open the safe for the first time, use the emergency key.
1. Remove the emergency keyhole cover. (1-2)
2. Insert the emergency key into the keyhole, turn it counterclockwise, then turn the knob clockwise to open the door. (3-4)
1
INSERTING THE BATTERIES
1. Open the door.
2. Insert 4x AA batteries into the battery compartment.
• If both the red and green light are on at the same, it means that the battery is low and that new batteries should be inserted.
Caution:
• Make sure to insert the batteries with the correct polarity by observing the ''+'' and ''-'' symbols.
• The user's code should be reset whenever new batteries are inserted.
SETTING THE USER CODE
1. Open the safe, press the reset button, wait until the yellow light comes on and then input the code.
2. Input the new code (3-8 digits) and press the (A) or (B) button to confirm.
• You will hear a beep once the code has been accepted.
• If the yellow light flashes and a beep can be heard, it means that the code is invalid and the process will have to be repeated.

OPENING THE DOOR

1. Input your 3-8 digit code. Whenever a button is pressed, the safe emits a beep sound and the yellow light flashes.
2. Press the (A) or (B) confirming button. The green light will turn on.
3. Rotate the knob clockwise and pull outwards within 5 seconds to open the door.
Note:
• The preset code is ''159''. Input the user code again if the yellow light flashes and the safe emits beeping sounds.

CLOSING THE DOOR

1. Turn the knob counterclockwise to close the door.

AUTOMATIC LOCK

• 3 continuously wrong code entries will activate the warning beeps.
Attention:
• The keypad is disabled during the beeping.
• You can only stop the beeps by opening the safe with the emergency key or by removing the battery.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included
in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work, including maintenance and special adjustments, must only be carried out by technicians
of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer shall
not be liable for injuries and damages resulting from the use of non-conforming equipment.
2
WWW.NIKOLAOUTOOLS.GR
3
E N
4
3