Advertisement
Installing the Baffles
1. Using the dimensions shown in Figure 1, locate,
mark, and drill 7 holes (0.344 inch (9mm) dia.) in
the front of the deck.
2. Loosely secure the right and left baffles to the inside
of the deck with flange head bolts and flange nuts,
positioning them as shown in Figure 1.
3. Adjust the baffles to the desired height and tighten
the mounting fasteners.
4
5
5
5
2
1. Left deck baffle
2. Right deck baffle
3. Deck covers
Securing the Deck Covers
1. Loosen the knobs and remove the deck covers from
the deck.
2. On each side of the gearbox, remove the knob,
washer, and locknut secured to the deck mounting
tab. Discard the knob but retain the washer and
locknut.
3
6
1
Refer to this figure throughout the installation.
4. 1.12 inches (2.84 cm)
5. 10 inches (25.4 cm)
6. 18 inches (45.72 cm)
Note: Make sure the baffles are level and not bent.
A bent baffle could affect the quality of cut.
3
Figure 1
3. Loosely install a new bolt to each deck mounting tab
with the washer and locknut previously removed.
4. Install the deck covers and tighten the new bolts and
the existing knobs.
2
7
8
G011603
7. 18.75 inches (47.63 cm)
8. 3.25 inches (8.25 cm)
9. 4 inches (10.16 cm)
9
Advertisement
