Controls System Maintenance; Adjusting The Control-Handle Position - Toro 74923 Operator's Manual

6. Unhook the idler spring from the frame
80).
7. Remove the belt from the hydraulic-unit-drive
pulleys and the engine pulley.
8. Install the new belt around engine pulley and
the 2 drive pulleys.
9. Using a ratchet in the square hole in the idler
arm, install the idler spring to the frame
80).
10. Install the mower belt; refer to
Mower Belt (page
(Figure
(Figure
Replacing the
54).
Controls System
Maintenance
Adjusting the
Control-Handle Position
There are 2 height positions for the control
levers—high and low. Remove the bolts to adjust the
height for the operator.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the bolts and flange nuts installed in the
levers (Figure
4. Align the levers in the front-to-rear position by
bringing the levers together to the N
position, and slide them until they are aligned,
then tighten the bolts
1. Bolt
2. Handle
56
EUTRAL
81).
EUTRAL
(Figure 82).
Figure 81
3. Control lever
4. Nut
-
LOCK
g009040