Gas Connection - Nexgrill CUCINA 720-1089 Operating Instruction

Gas Connection

LPG Gas Bottle
Gas Connection
LPG:
IMPORTANT: An LPG Bottle must be purchased separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the grill must be used. Replacement gas pressure
regulator/hose assembly specific to your model is available
from your outdoor grill dealer.
To Connect the LPG Bottle:
1. Check LPG gas fuel tank is in the "OFF" position. If not,
turn the valve clockwise until it stops.
2. Check that the burner control knobs are in the "OFF"
position.
3. Remove any debris and inspect the valve connections,
port, and gas pressure regulator/hose assembly for
damage.
NOTE: Always keep the LPG cylinder at 90
orientation to provide vapor withdrawal.
4. Some regulators push ON to connect and pull OFF to
disconnect, whereas others have a nut that either have a
left-hand or a right-hand thread that connects to the
cylinder valve. Identify your regulator type and follow the
connection instructions specific to that regulator.
Connect by Turning Clockwise
Screw regulator onto cylinder by turning the connecting
nut clockwise.
Connect by Turning Anti-Clockwise
Screw regulator onto cylinder by turning the connecting
nut anti-clockwise.
Connect by Turning Lever/Snapping into Position
Turn regulator lever clockwise to the OFF position. Push
regulator down on cylinder valve until your hear the
audible 'click'. Check that the regulator is fully locked
and in place by gently pulling upwards. If regulator
disengages, repeat procedure.
Connect by Sliding Collar
Make sure regulator lever is in the off position. Slide the
retaining ring of the regulator up. Push the regulator
down onto the cylinder valve and maintain downward
pressure on the regulator. Slide retaining ring down to
lock regulator onto cylinder valve. Check that the
regulator is secured. If the regulator disengages, repeat
procedure.
Note: If your grill is not equipped with a hose and regulator
assembly, please refer to the "European Gas Pressures
and Specifications" table to clarify the regulator gas
pressure and orifice size required.
Gas hose assemblies shall comply with AS/NZS 1869.
Make sure that the cylinder valve connection device
properly mates with the connection device attached
to the inlet of the pressure regulator.
8
(upright)
º
A. Gas pressure regulator
/ hose assembly
B. LPG Bottle