Rain Low: Why Is My Rainfall Reading Low; Rain High: Why Is My Rainfall Reading High - La Crosse Technology V22V2 Faqs

Table of Contents

Advertisement

If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient – these stations
can reconnect on, after many hours out.
RF (radio frequency) communication is not always 100% on. Certain temporary conditions can cause it to go
out for a time (e.g., 100% humidity).
If a miss happens:
If your rain sensor loses connection to your station for any reason, the station will show dashes after 30
minutes.
The station will search for 5 minutes every hour to reconnect with rain sensor.
Be sure you have good batteries. Manually search for your sensor.
Try this:
Bring your rain sensor within 10 feet of your station and make sure it is connected to the station. Your station
will show 0.00 for rain when connected and no rain has occurred.
After 15 minutes move the rain sensor into the next room with a wall between the sensor and the station for 1
hour.
If there is no loss of signal in that hour, move the rain sensor just outside.
Continue moving the rain sensor back to its original location.
If you lose connection, look for sources of interference.
Low rain readings indicate the rain sensor and station are connected.
Check that the rocker tips freely.
Check the funnel and the inside of the rain sensor for insect nests or debris that may cause loss of rocker
motion.
Be sure to mount the rain sensor level.
Complete a Tip Test:
Write down the Total Rain reading or reset the Rain Total to 0.00. With the rain sensor mounted slowly pour water
into the funnel to tip the rocker of the rain sensor 10 times. Wait at least 2 minutes for all the rain to collect. Repeat
three times.
Compare these tests. If they are the same, then your rain is reading correctly. If the rain readings are different,
repeat the test 3 times to avoid human error. Then look for causes such as mounting too tight or debris
clogging the funnel.
Check for sources of RF (radio frequency) interference such as other wireless rain sensors, ham radios or
electric transformers.
Keep the station six feet from cordless phones or wireless routers etc.
Complete a Tip Test:
Write down the Total Rain reading or reset the Rain Total to 0.00. With the rain sensor mounted slowly pour water
into the funnel to tip the rocker of the rain sensor 10 times. Wait at least 2 minutes for all the rain to collect. Repeat
three times.

RAIN LOW: WHY IS MY RAINFALL READING LOW?

RAIN HIGH: WHY IS MY RAINFALL READING HIGH?

17 |
P a g e

Advertisement

Table of Contents
loading

Table of Contents