iRobot RCA-Y1 Owner's Manual page 13

Washing the Bin
Important: Do not wash the filter.
Remove the filter before washing the bin.
1
Release the bin, remove the filter, and
open the bin door.
2
Rinse the dust bin and water tank using
warm water.
Note: Bin is not dishwasher safe.
3
Make sure bin is completely dry. Reinsert
filter and place bin back in the robot.
Cleaning the Filter
1
Remove the bin. Remove the filter by
grasping both ends and pulling out.
2
Remove debris by tapping the filter against
your trash container.
3
Reinsert filter with ridged grips facing out.
Place bin back in the robot.
Important: The robot will not run if the filter
is not installed correctly. Replace the filter
every two months.
Cleaning the Front Caster Wheel
1
Pull firmly on the front wheel module to
remove it from the robot.
2
Pull firmly on the wheel to remove it from its
housing (see illustration below).
3
Remove any debris from inside the
wheel cavity.
4
Reinstall all parts when finished.
Make sure the wheel clicks back into place.
Axle
Housing
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
Roomba Combo® j9+ Owner's Guide
EN
Wheel
9