Advertisement
Figure 3
1. Motor
2. Spline shaft
g014690
3. Cavity
4. Motor retaining bar
2
Removing the Tri-Roller
Unit
No Parts Required
Procedure
1.
Park the machine on a clean level surface,
lower the tri-roller units to the ground until the
suspension hydraulics are fully extended, shut
off the engine, engage the parking brake, and
remove the key from the ignition switch.
2.
Push the motor retaining bar out of the slots on
the motor toward the tri-roller unit and remove
the motor from the tri-roller unit.
1. Motor
3.
Move the motor to the storage location on the
front of the suspension arm.
Note:
Do not raise the suspension to the
transport position when the reel motors are in
the holders in the machine frame. Damage to
the motors or hoses could result. If you must
move the traction unit without the tri-roller units
installed, secure them to the suspension arms
using cable ties.
4.
Open the latches on the suspension-arm bar of
the tri-roller unit you are removing.
5.
Disconnect the latches from the tri-roller unit bar.
6.
Roll the tri-roller unit out from under the
suspension arm.
2
Figure 4
2. Motor retaining bar
g014605
Advertisement
