Table of Contents
Advertisement
Instructional Procedures for the Installation of AUTO
CRANE INFINITY Geared Rotary Screw Air
This air compressor should be installed only by those who have been trained and delegated to do
so and who have read and understand both the operators' manual and the installation manual.
Failure to follow the instructions, procedures, and safety precautions in this manual may result in
accidents and injuries.
Install, use, and operate this air compressor only in full compliance with all pertinent O.S.H.A.
requirements and all pertinent Federal, State, and Local codes or requirements and with AUTO
CRANE instructions.
Do not modify this compressor except with written factory approval.
1. MOUNTING COMPRESSOR
When mounting the compressor care should be taken to ensure that its location does not impede
the operation of other components on the vehicle. For example, if your vehicle is equipped with a
crane, you must make sure the compressor will not interfere with the swing of the crane. In
addition, the compressor should be installed in an area that permits cool ambient air to enter the
air filter and the hot air from the cooler to exhaust without recirculating into the air filter. One last
consideration in the mounting should be the routing of hoses and electrical wires. The frame
mounting holes are shown below and the unit should be secured to the vehicle with 3/8 inch grade
8 bolts, washers should be used on the mounting surface. Hardware supplyed with unit, may not
work in all applications.
+12V POWER (16 GA. YELLOW)
SPEED CONTROL OUT (16 GA. ORANGE)
GROUND (14 GA. BLACK)
+12V POWER (14GA. RED)
Compressor
6.42
11.42
17.75
38
TRUCK MOUNTING SURFACE
7/16" DIA.
6-PLACES
9.59
22.66
32.25
Advertisement
Table of Contents
