Advertisement
C H A P T E R 6 - C O N F I G U R A T I O N U T I L I T Y
16
P C S E T T I N G S P A G E
The PC Settings page is shown below, as it will appear the first time the program is run.
Select the correct product in the Product pull-down menu. Doing this will automatically select the default
baud rate for that particular transceiver. If the COM port is listed as unavailable, a different COM port can
be selected in the Port pull-down menu. The software can use two serial ports if the Enabled: box is
checked.
P O R T 1 / P O R T 2 O P T I O N S
The software can control up to (2) COM ports including virtual COM ports, which physically map to USB or
Ethernet ports. The Port pull-down menu allows selection of COM1 through COM16. An error message will
be displayed if a port is selected that is either nonexistent or already occupied by another software
program. When a port selection is made, the software will attempt to open the port and list its status as;
Unavailable, Open or Closed. Although menus are shown for Data Bits, Parity and Stop Bits, only the Parity
menu selection can be changed.
F I N D P O R T S B U T T O N
If the available COM ports are unknown, the Find Ports button can be pressed to update the COM Port pull-
down menu with all available COM ports.
1 - 8 0 0 - 4 9 2 - 2 3 2 0
w w w . a e r o c o m m . c o m
Advertisement
