Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AeroComm ConnexModem
Summary of Contents for AeroComm ConnexModem
- Page 1 ConnexModem & ConnexPC User’s Manual Version 1.0...
-
Page 2: Document Information
Document Information Copyright © 2001 A , Inc. All rights reserved. Copyright The information contained in this manual and the accompanying Information software programs are copyrighted and all rights are reserved by , Inc. A , Inc. reserves the right to make periodic modifications of this product without obligation to notify any person or entity of such revision. -
Page 3: Fcc Information
FCC Information FCC Notice WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. - Page 4 Table of Contents OVERVIEW ........................5 & C PC D ..............5 ONNEX ODEM ONNEX EFINITIONS WINDOWS MODEM SETUP & CONFIGURATION............5 TROUBLESHOOTING....................9 6/3/2002...
-
Page 5: Windows Modem Setup & Configuration
4. Tx: Green LED indicates a unit is sending data. 5. Dual RJ11 Jack: There are 2 standard telephone jacks on the ConnexModem unit. The phone line can be connected to either jack. The other jack can be connected to a telephone. - Page 6 ConnexModem & ConnexPC User’s Manual 2. If the Standard 56000 bps K56Flex Modem is not installed, click Add… to install a new modem. 3. Select Other when asked what type of modem you want to install, then click on Next>.
- Page 7 ConnexModem & ConnexPC User’s Manual 5. Select “(Standard Modem Types)” from the Manufacturers list, then select “Standard 56000 bps K56Flex Modem” from the Models list. Click Next> to continue. 6. Select the port to use with the modem and click Next> to continue.
- Page 8 115200 for the Maximum speed. Do not select “Only connect at this speed”, as this will not allow communications from the ConnexPC unit to the ConnexModem unit. 10. Click the Connection tab. Select 8 Data bits, None for Parity, 1 for Stop bits. Select “Wait for dial tone before dialing”.
- Page 9 ConnexModem & ConnexPC User’s Manual 11. Click Advanced… to continue. Select “Use flow control” and then select “Hardware (RTS/CTS)”. Click OK to return to the Standard 56000 bps K56Flex Modem Properties window. Click OK to return to the Modems Properties window. Click Close to complete the configuration.