Adjusting A Headlight Beam; Replacing The Tail/Brake Light Bulb - Yamaha Grizzly 700 2011 Manual

1. Do not touch the glass part of the bulb.
6. Connect the headlight coupler.
7. Install the headlight bulb cover. NOTICE:
Make sure the headlight bulb cover is se-
8
curely fitted and seated properly.
8. Install the cover at the rear of the headlight.
9. Adjust the headlight beam if necessary.
EBU25551

Adjusting a headlight beam

ECB00690
NOTICE
It is advisable to have a Yamaha dealer make
this adjustment.
To raise a headlight beam, turn the headlight beam
adjusting screw in direction (a).
To lower a headlight beam, turn the adjusting
screw in direction (b).
1. Headlight beam adjusting screw
[ECB01080]
EBU25642

Replacing the tail/brake light bulb

If the tail/brake light bulb burns out, replace it as
follows.
1. Remove panel H. (See page 8-10.)
2. Remove the tail/brake light bulb holder (to-
gether with the bulb) by turning it counter-
clockwise.
8-63