Fasten The Door Bracket - Chamberlain LiftMaster SECURITY+ 2500 Owner's Manual

INSTALLATION STEP 11

Fasten the Door Bracket

Follow instructions which apply to your door type
as illustrated below or on the following page.
A horizontal reinforcement brace should be long
enough to be secured to two or three vertical
supports. A vertical reinforcement brace should
cover the height of the top panel.
Figure 1 shows one piece of angle iron as the
horizontal brace. For the vertical brace, 2 pieces of
angle iron are used to create a U-shaped support.
The best solution is to check with your garage door
manufacturer for an opener installation door
reinforcement kit.
NOTE: Many door reinforcement kits provide for
direct attachment of the clevis pin and door arm. In
this case you will not need the door bracket; proceed
to Step 12.
SECTIONAL DOORS
1. Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation. Note correct UP placement, as
stamped inside the bracket.
2. Position the top edge of the bracket 2"-4" below
the top edge of the door, OR directly below any
structural support across the top of the door.
3. Mark, drill holes and install as follows, depending
on your door's construction:
Metal or light weight doors using a vertical angle
iron brace between the door panel support and
the door bracket:
• Drill 3/16" fastening holes. Secure the door bracket
using the two 1/4"-14x5/8" self-threading screws.
(Figure 2A)
• Alternately, use two 5/16" bolts, lock washers and
nuts (not provided). (Figure 2B)
Metal, insulated or light weight factory reinforced
doors:
• Drill 3/16" fastening holes. Secure the door bracket
using the self-threading screws (Figure 3).
Wood Doors:
• Use top and bottom or side to side door bracket
holes. Drill 5/16" holes through the door and secure
bracket with 5/16"x2" carriage bolts, lock washers
and nuts (not provided). (Figure 4)
NOTE: The 1/4"-14x5/8"
self-threading screws are
not intended for use on
wood doors.
To prevent damage to garage door, reinforce inside of
door with angle iron both vertically and horizontally.
Figure 1
Vertical
Reinforcement
Door
Bracket
Figure 2A
HARDWARE
Figure 3
SHOWN
ACTUAL SIZE
Self-Threading
Screw
1/4"-14x5/8"
20
WARNING
CAUTION
Header
Bracket
Door
Bracket
Location
HORIZONTAL AND VERTICAL
REINFORCEMENT IS NEEDED
FOR LIGHTWEIGHT GARAGE
DOORS (FIBERGLASS,
Vertical
Centerline ALUMINUM, STEEL, DOORS
WITH GLASS PANEL, ETC).
(NOT PROVIDED)
(Not Provided)
Bolt
Vertical
5/16"-18x2"
Centerline
UP
Self-Threading
Screw
1/4"-14x5/8"
(Not Provided)
Vertical
Centerline
UP
Self-Threading
Screw
1/4"-14x5/8"
Vertical
Reinforcement
Vertical
Centerline
UP
Door
Bracket
Lock Washer
5/16"
Nut
5/16"-18
Figure 2B
Inside Edge
of Door or
Reinforcement Board
Bolt
5/16"x2"
UP
Vertical
Centerline
Figure 4