Into The Rear Paper Feed Slot - Epson XP-700 Series Basic Manual

Basic Guide
F
Slide the edge guides to the edges of the paper.
G
Keep the cassette flat and insert it back into the
product carefully and slowly.
Note:
❏ Leave enough space in front of the product for the
paper to be fully ejected.
❏ Do not remove or insert the paper cassette while the
product is operating.

Into the rear paper feed slot

Note:
❏ Rear paper feed slot may not be available for some
models.
❏ Even though you can print on paper with a thickness
of 0.05 to 0.6 mm, some hard paper may not be fed
correctly even if the thickness is within this range.
A
Send your print job to the product (from your
computer, or by using the control panel).
Note:
Before sending your print job, you cannot load paper into
the rear paper feed slot.
Paper and Media Handling
B
Open the rear paper feed slot cover and then pull
out the paper support.
C
Slide the edge guide.
D
Load a single sheet of paper with the printable
side face-up at the center of the rear paper feed
slot, and then set the edge guide. The printable
side is often whiter or brighter than the other
side.
7