Table of Contents
Advertisement
Cleaning
en
Removing panels
Press on the left- and right-hand sides of the cover
1.
(fig.°
).
!
Remove the cover (fig.
2.
Lift out the inner panel (fig.
3.
carefully on a flat surface.
If necessary, you can remove the condensate trough
4.
for cleaning. To do this, open the appliance door
fully (fig.
).
$
Tilt the condensate trough up and remove it (fig.
5.
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Components inside the appliance door may have
Risk of injury!
■
sharp edges. Wear protective gloves.
22
).
"
) and set it down
#
Fitting panels
Open the appliance door fully and refit the
1.
condensate trough. To do this, insert the trough from
above and rotate it at the bottom (fig.
Push in the inner glass panel.
2.
Before sliding the panel in, make sure that the
glossy side of the panel is on the outside and the
cut-outs on the left and right are at the top.
The panel must be sitting correctly at the bottom in
the retainer (fig.
).
%
Push the inner panel in at the top (fig.
3.
Put the cover back in place and press on it until you
4.
hear it click into place (fig.
Open the appliance door again fully.
5.
Close the two locking levers on the left and right
6.
(fig.
)
%
Close the appliance door.
7.
!
).
"
#
).
$
).
).
Advertisement
Table of Contents
