Daikin FTKF25XVMV Operation Manual page 19

[Flow of function]
MOLD PROOF setting
Automatic
start every time
Set function
during COOL
or DRY
MOLD PROOF setting
Manual
start one time
Set function
during stop
NOTE
„ Notes on MOLD PROOF setting
• When you want to stop MOLD PROOF operation midway, press
• This operation dries the inside of the air conditioner while streamer discharge is performed to
reduce the development of mold and odour inside the air conditioner. But the function does not
remove any adhered dust and mold.
• MOLD PROOF operation is not available when the unit is turned off using the OFF TIMER.
„ Notes on MOLD PROOF operation
• The flap may sometimes close to increase the drying effect inside the air conditioner.
• MOLD PROOF operation may not be performed if the COOL or DRY operation less than 5 minutes
(from turn on remote controller).
In some case you should wait for about 3 minutes more (see Troubleshooting
• If MOLD PROOF operation does not suit your preference, please stop operation.
MOLD PROOF operation
with streamer
The heat exchanger is
dried in fan only operation
for about 60 mins.
During this time, the flap
will open and air is emitted.
After
stop
(The STREAMER
lamp blinks)
MOLD PROOF operation with streamer
The heat exchanger is
cleaned in cooling operation
for about 60 mins.
During this time, the unit will
operate in cooling mode.
Immediately
[Note]
During operation, cold air
blows out and the room
temperature may drop.
Stop
Automatic
stop
The heat exchanger is
dried in fan only operation
for about 60 mins.
During this time, the flap
will open and air is emitted.
After
stop
(The STREAMER
lamp blinks)
twice.
OPERATION
Stop
Automatic
stop
for details.).
Page 26
Page 16
17