Cleaning The Gas Barbecue; Exterior Surfaces; Interior Surfaces; Interior Surface Of The Barbecue Tray - Profi Cook PC-GG 1256 Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

Problem
Possible Cause
No yellow flame
Gas cylinder is too small Use a larger cylinder
or back coupling
Burner blocked (insect
(fire in the burner
nest?)
line – hissing or
The gas jets or hose is
bubbling noise)
blocked
Draft

Cleaning the Gas Barbecue

WARNING: HOT SURFACES
Before cleaning, wait until the gas barbecue has cooled down sufficient-
ly.
WARNING: RISK OF FIRE AND EXPLOSION
• Before cleaning the gas barbecue, remove the gas cylinder.
• Do not use any flammable detergents.
CAUTION:
• Do not use a wire brush or other abrasive utensils for cleaning.
• Do not use any oven cleaners. Oven cleaner attacks painted surfac-
es.
• Clean the barbecue after each use!
NOTE:
If you allow both burners to burn at full power for approx. 15 minutes
without food, the residual deposits will be burn away completely.

Exterior Surfaces

• Use mild detergents, caustic soda and hot water.
• Mild abrasive agents can be used for stubborn stains.
• Following this, rinse thoroughly with water.

Interior Surfaces

Does the inner surface of the grill lid look as if paint may flake off? There
is burnt-on grease which is flaking.
1. Clean the surface thoroughly with highly concentrated, hot soap suds.
2. Rinse thoroughly with water and allow the lid to dry.

Interior Surface of the Barbecue Tray

1. Remove residue with a brush or a scraper.
2. Using soap suds and a sponge, finish by washing the surface.
3. Rinse thoroughly with water and allow the surface to dry.

Barbecue Grille

• Use mild soap suds.
• Mild abrasive agents can be used for stubborn stains.
• Following this, rinse thoroughly with water.

Cleaning the Burner

1. Turn the adjustable knob to the 12 o'clock position (OFF).
2. Disconnect the gas cylinder.
3. Remove the grille.
4. Clean the burner with a soft brush or compressed air, and wipe down
with a cloth.
5. Clean clogged ports with a pipe brush or a rigid wire.
6. Check the burner for damage (cracks or holes). In the case of dam-
age, refer to your service team or your gas technician.
PC-GG1256_IM

Servicing

Notes / Solution
Your gas barbecue should be serviced annually by a technician.
Clean the burner
Clean the jets and the
Your gas barbecue requires regular care in order to ensure that it keeps
hose
looking good.
Set the barbecue up in a
Contrary to popular perception, stainless steel is neither rust resistant nor
protected location
maintenance-free. Even high-quality stainless steel has to be regularly
cleaned. This prevents rust and other forms of corrosion.
Even brushed stainless steel, which is very popular nowadays, is suscep-
tible to corrosion without the right care. The medium-hard stainless steel
that has been built into your barbecue requires cleaning and protection.
This will ensure that you enjoy your barbecue for many years to come.
After assembling the barbecue, we recommend protecting it using olive
oil. Spread it in a thin layer on the accessible stainless steel surfaces with
a clean cloth. Following this, polish it and remove oil residue with a clean
cloth.
The tried and tested method of protection is not just suitable for use with
food, it also helps the cleaning process and the removal of fingerprints.
If repeated regularly, this procedure will save you the unpleasant job of
removing stubborn dirt.

Use of Protective Covers

If the barbecue is not used for a long time, it is a good idea to use protec-
tive covers. These are also recommended as soon as the barbecue has
been cleaned and dried out well.
When selecting the protective cover, make sure it allows air to pass
through.
Residual moisture and condensation can generate damaging, moist air
under the cover. If left for a long period, this moist air leads to corrosion,
even in the case of good quality steels.

Enamelled Surfaces

Enamel is an excellent surface coating but it breaks easily. As such,
handle enamelled parts carefully.
• Remove dust or dirt by hand in warm rinsing water with the addition of a
little hand dishwashing liquid.
• Be careful not to scratch enamelled surfaces.
• Never use oven cleaner for your gas barbecue. Oven cleaners attack
the painted surfaces of your barbecue. This damages the paintwork.
• If the barbecue is clean and dry, you can protect it with a blanket.
• Store the barbecue in a frost-free, dry room.
• Shut the valve of the gas cylinder and store it out of the reach of chil-
dren.
• Concerning storage, also refer to the information in the section entitled
"Safety Notes".
• The side shelves are foldable for space-saving storage. To do this, lift
the side shelf horizontally. See also figure 17.
Maintenance and Protection of
Stainless Steel and Enamel Surfaces

Storing the Gas Barbecue

27
21.12.22

Advertisement

Table of Contents
loading

Table of Contents