Chevrolet Silverado 2500 HD 2023 Owner's Manual page 290

The Running Lights connection may not
detect partial outages. Activate the light test
to check all trailer lamps. See Light Test
following.
Light Test
Touch Start Light Test to cycle the trailer
lights on and off to determine if they are
working. The test follows this sequence:
1. The running lights turn on first and
remain on throughout the sequence.
2. The brake lights turn on for about
two seconds.
3. The left turn signal light flashes three
times.
4. The right turn signal light flashes three
times.
5. The reverse lights turn on for about
two seconds.
6. Steps 2 5 repeat for approximately
one minute and 45 seconds, or until the
test deactivates.
Touch Stop to stop the test. The test will
automatically end after one minute and
45 seconds.
The sequence also deactivates when any of
the following occur:
The vehicle is turned off.
The transmission is shifted out of P (Park).
The brake pedal is pressed.
The turn signal is activated.
The hazard warning lights are activated.
Tires
1. Trailer Tire Pressure/Temperature
Tire Pressure and Temperature
If the TTPMS sensor-to-vehicle learn process
was completed, the status view will display
the current tire pressure and temperature of
the trailer tires related to the active Trailer
Profile. If a tire s pressure is low or high, the
color of the pressure value will be amber.
If a sensor malfunctions, the values are
dashed lines. If the screen displays Service
Driving and Operating
Tire Pressure Monitoring System , the
vehicle needs to be taken to a dealer for
service.
Maintenance
1. List of Maintenance Reminders
2. Add a New Maintenance Reminder
The Maintenance Status view displays
reminders. Touch a reminder to edit.
Touch + New Maintenance Reminder to go
to the Select New Reminder view.
The progress bar turns yellow when the
maintenance item reaches 90% complete.
The progress bar turns red when the
maintenance item reaches 100% complete.
289