Chevrolet Silverado 2500 HD 2023 Owner's Manual page 20

4. Repeat Step 3 two additional times. After
the third time all previously known
transmitters will no longer work with the
vehicle. Remaining transmitters can be
relearned during the next steps.
The DIC should now display READY FOR
REMOTE # 1.
Transmitter Pocket without Bucket Seats
(Lower Compartment)
Transmitter Pocket with Bucket Seats
5. Place the new transmitter in the
transmitter pocket/insert.
6. Press ENGINE START/STOP. When the
transmitter is learned, the DIC display
will show that it is ready to program the
next transmitter.
7. Remove the transmitter from the
transmitter pocket/insert and press
on the transmitter.
To program additional transmitters,
repeat Steps 5 7.
When all additional transmitters are
programmed, press and hold ENGINE
START/STOP for approximately
12 seconds to exit programming mode.
Keys, Doors, and Windows
8. Return the key back into the transmitter.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak or if there
is interference with the signal, the DIC may
display NO REMOTE DETECTED or NO
REMOTE KEY WAS DETECTED PLACE KEY IN
TRANSMITTER POCKET THEN START YOUR
VEHICLE when starting the vehicle.
To start the vehicle:
or
Transmitter Pocket without Bucket Seats
(Lower Compartment)
19