Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting
The phenomenon
The water temperature is
too high
Water flows from the body
of the appliance
Indicator do not light, water
does not heat up
No water flows from the hot
water tap
Water leak
Electrical principal diagram
~230V
Reasons
Damage to the water temperature
control system
1 Destruction of the inner tank
(corrosion)
2 The seal at the connection point
of the heating element is broken
1 Damage to the temperature
control device
2 The temperature limiter has been
activated or not activated
3 Damage to the temperature
limiting device
1. The water supply is turned off.
2 Too low water pressure
3 Closed cold water tap
The seal at the pipe connection is
broken
fig
Treatment failure
Contact a repair specialist
an authorized center
Contact a repair specialist
an authorized center
Contact a repair specialist
an authorized service center
Turn on the thermal switch,
following the instructions for
turning it on
Contact a repair specialist
an authorized service center
Wait until the water supply is
restored
Turn on the water heater again
when normal water pressure is
restored
Open the cold water supply tap
Replace joint seal
Power
indicator
Heating
indicator
8
Heating
element
15
Advertisement
Table of Contents
