Table of Contents
Advertisement
Available languages
Available languages
Service
1
Check the electrical plug and socket
as often as possible Reliable electrical
contact must be ensured, as well as
proper grounding The plug and socket
must not become excessively hot
2
If the water heater is not used for a long
time, especially in regions with low air
temperature (below °C), to prevent damage
to the water heater (due to freezing of water
in the internal tank), the water from the
heater should be drained
3
To ensure reliable operation of the water
heater for a long time and maintain
warranty obligations, it is recommended
that regular maintenance by specialists
of
authorized
recommended, during which the internal
tank is cleaned, salt deposits are removed
from the electrical heating elements of
the water heater, and the condition of
the magnesium anode is checked, in case
consumption of half or more is replaced
The frequency of maintenance of the
water heater depends on the hardness of
the water in the area Possible intervals
from 3 months to a year
The frequency of cleaning the tank depends
on the hardness of the water Cleaning must
be carried out by authorized service centers
In the warranty card, a note is required that
maintenance is carried out at least once
every 12 months
4
Preventive work must be carried out
with strict observance of the operating
instructions and safety precautions by
pressure relief hole
14
service
centers
drain handle
screw
fig
7
specialists of authorized service centers
5
In case of water overheating, the thermal
biopolar fuse breaks the electrical circuit on
both sides of the heating element In this
case, determine the cause of overheating
and reset the thermostat manually by
pressing the reset button located on the
thermostat (or, in case of a malfunction,
replace the thermostat)
6
Remember to check the operation of the
safety valve every 14 days Check method:
– move the drain handle to the upper
position until you feel the transition of
the thread, and then water should flow
from the valve hole
After checking the water flow, return the
handle to the previous position
is
7
Check periodically for scale and blockage
Drainage of the valve, in order to avoid
clogging, is carried out as follows: if the
valve has a lever, then it must be lifted
several times, if the valve is without a
lever, it must be unscrewed and scale
accumulations removed
Attention!
-
1
Never drain water if its temperature is
(1)
above 50 °C, as this may cause burns
2
If water does not flow, the valve is
TEST (2)
damaged In this case, the water heater
(3)
must not be used and it is recommended
to call a service technician
Advertisement
Table of Contents
