4
www.aeg.com
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from
being fully opened.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
The ventilation opening in the base (if applicable)
•
must not be covered by a carpet, mat, or any floor
covering.
Ensure good air ventilation in the located room to
•
avoid the backflow of unwanted gases into the room
from appliances burning gas or other fuels, including
open fires.
Exhaust air must not be discharged into a flue which is
•
used for exhausting fumes from any appliances
burning gas or other fuels.
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
Do not exceed the maximum load of 9 kg (refer to the
•
"Programme chart" chapter).
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Do not run the appliance without filters. Clean the lint
•
filter before or after each use.
Items that have been soiled with substances such as
•
vegetable or mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra