Heater; Refractory Materials And Baffle; Glass Door - Drolet Fox Small Owner's Manual

4.1

Heater

4.1.1 Cleaning and Painting
Painted and plated surfaces can be wiped down with a soft, damp cloth. If the paint is scratched
or damaged, it is possible to repaint the heater with a heat-resistant paint (see « Exploded
diagram and parts list » in the Wood Stove Installation and Operation Manual). Do not clean or
paint the appliance when it is hot. Before painting, the surface should be sanded lightly with
sandpaper and then wiped off to remove dust. Apply two thin layers of paint.
4.2

Refractory Materials and Baffle

Inspect the firebricks or the refractory panels and the baffle for damage periodically and replace
anything that is broken.
Operation of the heater with a cracked or missing baffle may cause unsafe temperatures
a n d h a z a r d o u s c o n d i t i o n s a n d w i l l v o i d t h e w a r r a n t y.
4.3

Glass Door

4.3.1 Cleaning
Under normal conditions, the door glass should stay relatively clear. If the firewood is dry enough
and the operating instructions in this guide are followed, a whitish, dusty deposit will form on the
inner surface of the glass after a week or so of use. This is normal and can be easily removed
when the heater is cold by wiping with a damp cloth or paper towel and then drying.
When the stove runs at a low combustion rate, light brown stains may form, especially in the
lower corners of the glass. This indicates that the fire has been smoky and some of the smoke
has condensed on the glass. It also indicates incomplete combustion of the wood, which also
means more smoke emissions and faster formation of creosote in the chimney.
The deposits that form on the glass are the best indication of the fuel quality and success in
properly using the stove. These stains can be cleaned with a special wood stove glass cleaner.
Do not use abrasive products to clean the glass.
The goal should be having a clear glass with no brown stains. If brown stains appear regularly on
the glass, something about the fuel or the operating procedure needs to be changed. When brown
streaks are coming from the edge of the glass, it is time to replace the gasket around the glass.
The glass gasket should be self-adhesive. Always replace the gasket with a genuine one.
Page 18
Do not clean the glass when the stove is hot.
Do not abuse the glass door by striking or slamming shut.
Do not use the stove if the glass is broken.
Wood Stove - Owner's Manual