Table of Contents
Advertisement
Available languages
Available languages
Preparing The Engine
For engines stored over 30 days:
•
To prevent gum from forming in fuel system or on carburetor parts, run
engine until it stops from lack of fuel or add a gasoline additive to the gas
in the tank. If you use a gas additive, run the engine for several minutes to
circulate the additive through the carburetor—after which the engine and
fuel can be stored up to 24 months.
•
While engine is still warm, change the oil.
•
Clean engine of surface debris.
OFF-SEASON STORAGE
Never store edger with fuel in tank indoors or in poorly ventilated areas
where fuel fumes may reach an open flame, spark, or pilot light as on a
furnace, water heater, clothes dryer, or gas appliance.
WARNING
Preparing The Edger
•
Clean and lubricate edger thoroughly as described in the lubrication
instructions.
•
Do not use a pressure washer or garden hose to clean your unit.
•
Coat edger blade with chassis grease to prevent rusting.
•
Refer to Preparing the Engine for correct engine storage instructions.
•
Store edger in a dry, clean area. Do not store next to corrosive materials, such
as fertilizer.
When storing any type of power equipment in a poorly ventilated or metal storage
shed, care should be taken to rust-proof the equipment. Using a light oil or silicone,
coat the equipment, especially cables and all moving parts of your edger before
storage.
14
Advertisement
Chapters
Table of Contents
