Light On/Off - HOME DECÓ 52560 Manual

blue wires are the hot wires (+) and the white wire is the neutral wire (-).
5. Install the fan blades: each blade has 3 holes. There are also 3 holes in the
electric motor part. Align the holes of both so that they coincide and insert
the fan blade supporter (7) and the screws to fix the blades to the main body.
To ensure that the weight is balanced, the blades must be installed diago-
nally. Assemble the fan blades one by one. Make sure each screw is tight.
Note: The fan blades must not be pressed.
6. Install the shade: put the glass shade at the end of the main body and fix it with the
screws. Remove both hands from the shade once you are sure it cannot fall.
7. The installation is finished.
Warnings:
- Be sure to check the screws indicated in the diagram. They must be firmly attached to
the downrod.
- The iron pin should be inserted in the location indicated by the arrow.
- Insert the R-shaped pin to prevent the piece from wobbling.
FIXING THE FAN TO THE CEILING
Once the fan is installed, make sure that the distance from the lowest part of the fan
to the ground is at least 2.30 m. This appliance can be attached to concrete ceilings
and wooden ceilings or beams. Always use the appropriate fixing systems to guarantee
the correct fastening of the appliance. Check that the chosen fixing point is capable of
supporting the weight of the moving fan.
START UP
The fan starts running when the extension chain connected to the 3-speed switch is
pulled. Select the desired speed:
• Pulling 1 = ON (High speed).
• Pulling 2 = ON (Medium speed).
• Pulling 3 = ON (Low speed).
• Pulling 4 = OFF.

LIGHT ON/OFF

By pulling the extension chain connected to the light switch, you can control the lighting
of the lamp:
• Pulling 1 = ON (Connected).
• Pulling 2 = OFF.