Power Saving Options; Stand By Mode; Save To Disk - Hibernate Mode; The Power On/Power Management Button - ViewSonic V1100 User Manual

Power Saving Options

When battery power reaches critical low (3% remaining), the system enters
either one of the two power saving modes:

• Stand By mode

• Hibernate Mode - Save To Disk
Stand By Mode
In Stand By mode, hardware devices, such as display panel and hard disk, are
turned off to conserve energy. Click Start > select Turn Off Computer > click
Stand By. To use the V1100 again, press the Power On button.

Save To Disk - Hibernate Mode

In this mode, all system data is saved to the hard disk before powering down.
When in the hibernate mode, very little power is drawn from the battery.
The amount of time the system requires to restore all its previous contents
depends on how much RAM has been installed on your V1100. Restoration
times can range from 5 to 20 seconds.
To enable the hibernation function, click Start > Control Panel > Performance
and Maintenance > Power Options > Hibernate Option > OK under the Enable
hibernation option.

The Power On/Power Management Button

The V1100 power On/Off button serves two functions: to turn the unit on and to
put the unit in Stand By (system power management). To turn the V1100 on,
press the power On button.
To put the V1100 in Stand By (also called deep sleep) with a flashing green
Power LED do one of the following:
• Tap the power button. If the On button is not set up to Stand by, click the
Windows Start button > Control Panel > Power Options > Advanced. Under
the Running on batteries column, select the time you want before the unit goes
into Stand By: power LED is flashing green. Or,
• Click Start > Turn Off Computer > Stand By.
To wake up the system from Stand By/deep sleep (black screen with a steady
green power LED, press the Power On button.
ViewSonic Tablet PC V1100 22