Lightfield-To-Winx - Princeton Instruments PIXIS System Manual

Appendix E

LightField-to-WinX

LightField
Active Area: Bottom Margin
Active Area: Left Margin
Active Area: Right Margin
Active Area: Top Margin
Active Area: Top Margin
Active Height
Active Width
Always Closed (Shutter)
Always Open (Shutter)
Analog Gain
Bit Depth
Clean Cycle Height
Clean Serial Register
Clean Until Trigger
Closing Delay
Custom Sensor
Custom Timing
Final Section Count
Final Section Height
Kinetics Window Height
N/A
No Response
No Response (Kinetics)
Normal (Shutter)
Number of Clean Cycles
Open Before Trigger (Shutter)
Output Signal
Output Signal: Always High
Output Signal: Always Low
Output Signal: Busy
Cross-Referencing of WinX and LightField Terms
WinX
Post-Dummy Rows Parallel to Shift Register
Pre-Dummy Shift Register Columns
Post-Dummy Shift Register Columns
F.T. Dummies or Frame Transfer Dummies
Pre-Dummy Rows Parallel to Shift Register
Active Rows Parallel to Shift Register
Active Shift Register Columns
Disabled Closed (Shutter)
Disabled Open (Shutter)
Controller Gain
ADC Resolution
Number of Strips per Clean
Skip Serial Register Clean (deselected)
Continuous Cleans
Shutter Close Compensation Time
Custom Chip
Custom Timing
Number of Blocks
Minimum Block Size
Window Size
Disable Pixel Bias Correction (PBC)
Free Run
Free Run (Kinetics)
Normal Shutter
Number of Cleans
PreOpen (Shutter)
Logic Out
Logic Out: Logic 1
Logic Out: Logic 0
Logic Out: Not Ready
123
123