Power Acoustik HD-14KIT Owner's Manual page 8

Installation
8. Disconnect electrical connections to the head unit.
8.1) Remove the main wire harness connector (1). To remove the main wire harness,depress the latch
locking tab wiht a small flathead screwdriver. While depressing the locking tab, pull the USB cable to
release it from socket.
8.2) Remove the USB cable connector (2). To remove the USB cable connector, depress the locking tab
wiht a small flathead screwdriver. While depressing the locking tab, pull the USB cable to release it from
socket.
8.3) Remove the radio antenna cable connector (3). To remove the radio antenna cable connector,
depress the locking tab wiht a small flathead screwdriver. While depressing the locking tab, pull the
antenna cable to release it from the socket.
8.4) Remove the GPS antenna cable connector (4). To remove the GPS antenna cable connector, depress
the locking tab wiht a small flathead screwdriver. While depressing the locking tab, pull the antenna cable
to release it from the socket.
8.5) Remove SiriusXM antenna cable connector, if equipped (5). To remove the Sirius XM antenna cable
connector, depress the locking tab with a small flathead screwdriver. While depressing the locking tab,
pull the Sirius XM antenna cable to release if from the socket.
9. Remove four head unit mounting screws using a 3/16" hex driver. Two screws are located at each
side of the headunit chassis. Store these screws in a safe place for re-installation later. Pull the headunit
assembly up and forward to remove.
1
2
8
4
3
8
5