Integrity 90290 User Instructions

Maximum Weight Limit: 15Kg
General Safety Warning
Please ensure that these instructions are
fully read and understood before
installation / use. Retain these
instructions in a safe place for future
reference. Do not exceed the weight limit
above – doing so could damage the
equipment of put the user at risk.
Before Use
Carefully remove all packaging. Aviod use of
knives or similar sharp instruments as these may
damage the surface of the product.
Check the product for any visible damage. If you
see any damage or suspect a fault, do not use
the product, but contact Integrity Mobility
Solutions for support.
Contents:
•
Wood finished table top
•
Chrome plated "L" shape support tubes
•
Painted tubular "H" section with black
threaded locking nuts x 2
•
U-shaped base with two short uprights
•
E-Clips x 2
Assembly
1. Carefully unpack the overbed adjustable
Table and examine all parts for any
damaged or loose fittings. Should you find
any fault, please contact Integrity Mobility
Solutions for an exchange.
2. After inspection, place the wooden finished
table-top face down onto a soft surface to
avoid any scratches and clip the chrome
plate tubes into the clips on the underside
of the table-top. Make sure both tubes are
vertical and level.
3. Take the two painted tubular sections with
the black threaded locking nuts attached &
slide these over each of the chrome plated
tubes, with the black locking nuts facing
downwards toward the table-top. Tighten
the nuts onto the chrome plated tubes.
Integrity Mobility Solutions Ltd 74, St. Georges Road, Bolton, Greater Manchester, BL1 2DD
Tel: +44 (0) 1249 760582 website: www.integritymobilitysolutions.com
90290 – Overbed Adjustable Table
User Instructions
4. The black locking nuts are designed to be
tightened onto the chrome plated tubes,
allowing the table-top to be positioned at
any height or angle without the risk of
collapse under its intended use. However,
the design of this unit is only meant to be
adjusted to a "Finger tight" pressure. Over
tightening of the locking nuts could result
in the plastic housing being damaged.
5. If already installed, remove the e-clips
from the U-shaped base upright tubes.
6. Take the U-Shaped base and place the
upright tubes inside the two tubular
sections of the "H" section already
attached to the chrome plated tubes.
7. Ensure that the pre-punched holes in both
painted tubular sections line up with each
other. (You may need to loosen the black
locking nuts. If so, be sure to retighten the
nuts once the alignment has been
achieved.)
8. Insert the two e-clips into the aligned holes
in the tubes, making sure that the e-clips
are fully located through both tubes.
FAILURE TO DO SO WILL MAKE THE
TABLE UNSTABLE.
N.B. Please note that over tightening of the
nuts in this way will invalidate the warranty on
this item, as this is misuse of the intended
application.