Integrity 90291 Assembly Instructions And User Manual

Over-Bed Table with Wheels – 90291
Assembly Instructions and User Guide
Thank you for choosing an Integrity Mobility Solutions Over-bed Table. This user guide should be read
carefully before you use the over-bed table, as it contains important information regarding the product,
including the safe operation and maintenance of it.
Package Contents
Before attempting to assemble this product check that all parts are present and complete. If any parts are
missing please contact your supplier.
Assembly
1) Push four castors into the holes in the underside of the frame base.
2) Remove the "E Clip" from each leg.
3) Place each leg over the base spigots.
4) Re-insert the "E Clips" to attach the legs to the spigots.
5) Unfold the support legs outwards. One support leg must be re-positioned before proceeding. Press the
spring button and slide it under the clip.
6) Slacken off the hand wheels and insert the support legs into the legs on the base. Tighten the hand wheels
to fix the table top at the required height and angle. Adjusting the angle when the table is in use the hand
wheels only require slackening a turn or two they do not need removing.
Integrity Mobility Solutions Ltd 74, St. Georges Road, Bolton, Greater Manchester, BL1 2DD
Tel: +44 (0) 1249 760582 website: www.integritymobilitysolutions.com
Product Dimensions
Width (mm) Length (mm)
410 680
Height
(From floor to top of table)
700mm – 1,000mm