Table of Contents
Advertisement
Water Hardness Table
ppm
°d
0
<4
75
4 - 7
125
7 - 14
250
14 - 21
375
>21
Setting the Water Softening
System
For effective washing results, adjust the setting
corresponding to the hardness level of water used
in water supply. The water softener has 5
adjustment levels, and the appliance is
programmed at the factory for a water hardness
level of H2. You can check the default setting value
and adjust it in the following steps:
1
Press Power and Half Load button
simultaneously.
• Current setting value indicated.
2
Press the Delay Start button, and then set up
the intended value.
• Scope of setting value is H0 to H4.
3
Press the START button to save the setting.
• The power turns off after saving.
NOTE
• The Salt Refill
icon turns on in the display if
n
dishwasher salt is not in the softening system.
• If the hardness setting is set to H0, no icon
indicates in spite of no salt.
Water Hardness
°e
°f
<5
<7
5 - 9
7 - 13
9 - 17.5
13 - 25
17.5 - 26
25 - 38
>26
>38
mmol/l
mg/l
(Ca+Mg)
(Ca)
<0.7
<29
0.7 - 1.3
29 - 50
1.3 - 2.5
50 - 100
2.5 - 3.8
100 - 150
>3.8
>150
Filling with Dishwasher Salt
The salt dispenser must be filled with salt before
starting the washing programme. In case of
insufficient salt, the Salt Refill
the display, unless the hardness level has been set
to H0.
CAUTION
• Once you have filled with dishwasher salt you
must run the Rinse cycle immediately to remove
the salt and the salt water around the inner tub
in order to prevent corrosion.
1
Remove the lower rack and remove the cap of
the salt dispenser located on the left side of the
filters.
2
Before using the appliance for the first time, it
is necessary to pour 1 kg of dishwasher salt
and 1 litre of water at the same time if
intending to use the water softener system.
OPERATION
23
Softening
level
Range
Soft
H0
H1
H2
H3
Hard
H4
n
icon indicates on
Advertisement
Table of Contents
