Craftsman CX Series Operator's Manual page 35

Craftsman Snow Thrower Model 247.883981
777S32280
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN STICK TO
UNCLOG DISCHARGE CHUTE.
AUGER CONTROL
GO
PARTS LIST
777D18046
777S32636
DANGER
1. KEEP AWAY FROM ROTATING IMPELLER AND AUGER. CONTACT
WITH IMPELLER OR AUGER CAN AMPUTATE HANDS AND FEET.
2. USE CLEAN-OUT TOOL TO UNCLOG DISCHARGE CHUTE.
3.
DISENGAGE CLUTCH LEVERS, STOP ENGINE, AND REMAIN BEHIND
HANDLES UNTIL ALL MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING OR SERVICING MACHINE.
4.
TO AVOID THROWN OBJECTS INJURIES, NEVER DIRECT
DISCHARGE AT BYSTANDERS. USE EXTRA CAUTION WHEN
OPERATING ON GRAVEL SURFACES.
5.
READ OPERATOR'S MANUAL.
CLEAN-OUT TOOL
777I22340
LEFT TURN
TRIGGER CONTROL
777D18038
777D16340
777I23013
ON OFF
RIGHT TURN
DRIVE CONTROL
TRIGGER CONTROL
35
777I22341
CHUTE DIRECTIONAL CONTROL
DISCHARGE DISCHARGE
LEFT RIGHT
CHUTE TILT
DOWN
CHUTE TILT
UP
STARTING INSTRUCTIONS:
1.) INSERT KEY AND SNAP IN PLACE.
2.) MOVE THROTTLE CONTROL TO THE "FAST"
POSITION.
3.) MOVE CHOKE CONTROL TO THE "CHOKE"
POSITION. PUSH PRIMER 3x.
4.) ROPE START: PULL SLOWLY UNTIL HARDER
TO PULL, THEN PULL RAPIDLY TO START.
REPEAT PRIMING IF NEEDED.
ELECTRIC START: DO NOT USE IN RAIN.
CONNECT POWER CORD AND PUSH STARTER
BUTTON. REPEAT PRIMING IF NEEDED.
5.) MOVE CHOKE CONTROL SLOWLY TO THE
"RUN" POSITION.
6.) TO STOP ENGINE: MOVE THROTTLE TO THE
"STOP" POSITION.
777D16353
cc
420 420
OVERHEAD VALVE
777I22363
G0