Philips 16B1P3300 User Manual page 4

Portable monitor
Table of Contents

Advertisement

bezel, ensure that the monitor does
not tilt downward by more than -5
degrees. If the -5 degree downward
tilt angle maximum is exceeded, the
monitor damage will not be covered
under warranty.
Do not knock or drop the monitor
during operation or transportation.
Excessive usage of monitor can cause
eye discomfort, it's better to take
shorter breaks more often at your
workstation than longer breaks and
less often; for example a 5-10 minute
break after 50-60-minute continuous
screen use is likely to be better than
a 15-minute break every two hours.
Try to keep your eyes from eye strain
while using the screen for a constant
period of time by :
• Looking at something varying
distances after a long period
focusing on the screen.
• Conscious Blinking often while
you work.
• Gently closing and rolling your
eyes to relax.
• Reposition your screen to appro-
priate height and angle according
to your height.
• Adjusting the brightness and
contrast to appropriate level.
• Adjusting the environment light-
ing similar to that of your screen
brightness, avoid the fluorescent
lighting, and surfaces that don't
reflect too much light.
• Seeing a doctor if your symp-
toms.
Maintenance
To protect your monitor from
possible damage, do not put
excessive pressure on the LCD panel.
When moving your monitor, grasp
the frame to lift; do not lift the
monitor by placing your hand or
fingers on the LCD panel.
Oil-based cleaning solutions may
damage the plastic parts and void the
warranty.
Unplug the monitor if you are not
going to use it for an extensive
period of time.
Unplug the monitor if you need to
clean it with a slightly damp cloth.
The screen may be wiped with a
dry cloth when the power is off.
However, never use organic solvent,
such as, alcohol, or ammonia-based
liquids to clean your monitor.
To avoid the risk of shock or
permanent damage to the set, do
not expose the monitor to dust,
rain, water, or excessive moisture
environment.
If your monitor gets wet, wipe it with
dry cloth as soon as possible.
If foreign substance or water gets in
your monitor, please turn the power
off immediately and disconnect
the power cord. Then, remove the
foreign substance or water, and send
it to the maintenance center.
Do not store or use the monitor in
locations exposed to heat, direct
sunlight or extreme cold.
In order to maintain the best
performance of your monitor and use
it for a longer lifetime, please use the
monitor in a location that falls within
the following temperature and
humidity ranges.
• Temperature: 0-40°C 32-104°F
• Humidity: 20-80% RH
Important information for Burn-in/Ghost
image
Always activate a moving screen
saver program when you leave
your monitor unattended. Always
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

3000 series

Table of Contents