Table of Contents
Advertisement
7.
Push the hex rod toward the control panel until the hole
in the hex rod lines up with the hole in the chute control
input closest to the chute control head and insert the
cotter pin. See Fig. 3-8.
Note: The second hole is used to achieve further
engagement of the hex rod into the pinion gear if required.
Refer to page 19 for Chute Control Rod adjustments.
Figure 3-8
8.
Finish securing chute control head to chute support
bracket with wing nut, clevis pin, and bow-tie cotter pin
removed in step 1. See Fig. 3-2.
9.
Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-9.
Note: For smoothest operation, the cables should all be to
the left of the hex rod.
Figure 3-9
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow
thrower's dash panel until needed. See Fig. 3-10.
Figure 3-10
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-11.
Figure 3-11
S
ection
Chute Clean-Out
Tool
3 — A
& S
-U
SSembly
et
p
9
Advertisement
Table of Contents
