Table of Contents
Advertisement
Quick Links
4 Burner Gas Grill
OWNER'S MANUAL
ASSEMBLY AND OPERATING IN STRUC TIONS
SAVE THIS MANUAL FOR FUTURE REFERENCE
Model GAS3400AS
WARNING
NOTICE TO INSTALLER:
HAZARDOUS EXPLOSION MAY RESULT IF THESE
LEAVE THESE INSTRUCTIONS WITH
WARNINGS AND INSTRUCTIONS ARE IGNORED. READ
THE GRILL OWNER FOR FUTURE
AND FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THIS
MANUAL TO AVOID PERSONAL INJURY, INCLUDING DEATH
REFERENCE .
OR PROPERTY DAMAGE.
Advertisement
Table of Contents
Related Manuals for Even Embers GAS3400AS
Summary of Contents for Even Embers GAS3400AS
- Page 1 4 Burner Gas Grill OWNER’S MANUAL ASSEMBLY AND OPERATING IN STRUC TIONS SAVE THIS MANUAL FOR FUTURE REFERENCE Model GAS3400AS WARNING NOTICE TO INSTALLER: HAZARDOUS EXPLOSION MAY RESULT IF THESE LEAVE THESE INSTRUCTIONS WITH WARNINGS AND INSTRUCTIONS ARE IGNORED. READ...
- Page 2 IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL.
-
Page 3: Table Of Contents
TABLE OF CONTENTS: General Warnings ..........3-4 LP Gas Cylinder (Tank) Specifi cations and Installation . -
Page 4: General Warnings
GENERAL WARNINGS: WARNING • Leak test all connections before fi rst use, even if grill was purchased fully assembled and after each tank refi ll. Check the propane tank rubber seal for damage. • Always check the grill and propane tank prior to each use as indicated in the “Checking for Leaks” & “Pre-Start Check List”... -
Page 5: Lp Gas Cylinder (Tank) Specifications And Installation
• Grill is hot when in use. To avoid burns: • DO NOT attempt to move the grill. • Block the wheels so the unit does not accidentally move. • Wear protective gloves or oven mitts. • DO NOT touch any hot grill surfaces. •... - Page 6 LP GAS CYLINDER (TANK) SPECIFICATIONS: LP gas cylinder (not supplied with this grill) The LP (Liquid Propane) gas cylinder specifi cally designed to be used with this grill must be 12” (30.5 cm) diameter x 18” (45.7 cm) tall and have a 20 lb. (9.1 kg) capacity incorporating a Type 1 cylinder valve and an over-fi lling protection device (OPD).
-
Page 7: Hose & Regulator Specifications And Installation
LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION: • Inspect the propane tank valve rubber seal for cracks, wear or deterioration prior to use. A damaged rubber seal can cause a gas leak, possibly resulting in an explosion, fi re or severe bodily harm. •... -
Page 8: Leak Testing
HOSE AND REGULATOR: Your grill is equipped with a Type 1 connection device with the following features: 1. The system will not allow gas fl ow from the cylinder until a positive connection to the valve has been made. Note: The cylinder valve and all grill burner knobs must be turned OFF before any connection is made or removed. - Page 9 DANGER To prevent fi re or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS in a well ventilated area that is protected from the wind. • Never perform a leak test with a match or open fl ame.
-
Page 10: Pre-Start Check List
PRE-START CHECK LIST: DANGER Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual. -
Page 11: Operating The Grill
6. If burner does not ignite using the igniter, see “Match Lighting the Main Burners” section. To turn off, turn each control knob clockwise until it locks in the “OFF” position. This does not turn off the gas fl ow from the cylinder. Note: If burner does not light or fl ame is too low, See “Trouble Shooting”... - Page 12 • If grease fi re occurs while lid is open, leave lid open, turn burner knobs to “OFF” , turn off LP cylinder valve. If possible, relocate food to a different section of cooking grate and allow grease to burn out or smother the fl ames with baking soda.
-
Page 13: Proper Care And Maintenance
PROPER CARE & MAINTENANCE: WARNING: If a bristle brush is used to clean any of the cooking surfaces, ensure no loose bristles remain on the cooking surfaces prior to grilling as loose bristles may attach to food. CLEANING INTERIOR OF GRILL: •... - Page 14 BURNER ASSEMBLY/MAINTENANCE: • Although your burners are constructed of stainless steel, they may corrode as a result of the extreme heat and acids from cooking foods. Regularly inspect the burners for cracks, Debris abnormal holes, and other signs of corrosion damage. If found, replace the burner.
-
Page 15: Transporting And Storage
TRANSPORTING AND STORAGE: WARNING • Never move a grill when hot or in use. • Make sure that cylinder valve is closed and burner knobs are in the off position. • DO NOT store a spare LP gas cylinder (fi lled or empty) under or near the grill. •... - Page 16 Problem Possible Cause Prevention/Cure Electrode cracked or broken - sparks at crack Replace electrode Wire loose or disconnected Reconnect wire or replace electrode/wire assembly Wire is shorting (sparking) between ignitor and Replace ignitor wire/electrode assembly electrode Bad ignitor Replace ignitor Grill does not get hot Out of gas Replace or refi ll LP gas tank...
-
Page 17: Grill Cooking Tips
GRILL COOKING TIPS: CLEANLINESS: • Always wash hands thoroughly with soap and hot water prior to handling food and after handling raw meat, uncooked poultry or seafood. • When using a platter to carry raw meat, uncooked poultry or seafood to the grill, make sure to wash the platter thoroughly with soap and hot water before placing cooked foods back on the platter or use different platters for raw and cooked foods. -
Page 18: Assembly Instructions
BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN AS SEM BLING THIS UNIT. The following tools are required to assemble this Even Embers 4 Burner Gas Grill: • Phillips and Flat Head Screwdriver • Adjustable Wrench... - Page 20 Insert eight M6 x 15 mm bolts to left front leg right front leg halfway. ≈¼ inch Attach front panels left front leg and right front leg over keyholes and slide down. Secure using four M6 x 15 mm bolts. Tighten eight bolts.
- Page 21 Attach six M6 x 15 mm bolts to left rear leg right rear leg halfway. ≈¼ inch ≈¼ inch Attach rear cart brace to left rear leg and right rear leg over keyholes Tank Block and slide down. Secure Bar Holes using two M6 x 15 mm bolts.
- Page 22 Attach tank holder brace and left lower cart brace to front and rear legs over keyholes and slide down. Secure using four M6 x 15 mm bolts. Tighten eight bolts. Note: Make sure the tank holder brace prongs are on the inside as illustrated.
- Page 23 Attach wheels to right legs using M10 x 98 mm and four M12 washers and two M10 lock nuts. Attach upper left cart brace and upper right cart brace over keyholes and slide down. Secure using six M6 x 15 mm bolts. Tighten ten bolts.
- Page 24 Remove 10 M6 x 15 mm bolts and remove protective brackets. Keep bolts for later use. Attach temperature gauge and temperature gauge bezel to hood glass using washer and wing nut.
- Page 25 Insert four M6 x 15 mm bolts to grill body halfway. Loosen two M6 bolts halfway. ≈¼ inch Loosen ≈¼ inch 2 Bolts Set grill body on cart frame. Secure using six M6 x 15 mm bolts through left side cart brace and right side cart brace...
- Page 26 Insert four M6 x 15 mm bolts to left side front panel and right side front panel halfway. Attach left side table and right side table over keyholes and slide down. Secure using two M6 x 15 mm bolts. Tighten all six bolts.
- Page 27 Secure side tables using four M6 x 15 mm bolts. Secure front panels to grill body using two M6 x 15 mm bolts.
- Page 28 Attach hood handle hood handle bezels using two M6 x 30 mm bolts and M6 washers. Install four studs into fi rebox rear wall.
- Page 29 Insert four heat tents two cooking grates warming rack Attach four control knobs...
- Page 30 Attach two tank block bars by inserting hooked end into hole in back of the front panel, then secure using two M6 x 15 mm bolts and M6 washers. Install upper tank holder by inserting fl at end into slot in right front leg hooked end into hole in right rear leg Right Front...
- Page 31 Remove two bolts from grease tray handle . Place handle on outside and reattach. Slide grease tray and into back of grill.
- Page 32 Insert grease cup into grease cup holder . Hang grease cup from hole in grease tray Even Embers GAS3400AS Assembled...
- Page 33 WARRANTY The Boltz Group warrants to the original pur chas er that the Even Embers 4 Burner Gas Grill is free from defects due to workmanship or materials for: Ten-year: on stainless steel tube burners Three-year: on all other stainless steel parts One-year: on valves, frame, housing, cart, igniter, cooking grates and other related parts The Boltz Group’s obligations under this warranty are limited to the following guidelines:...
Need help?
Do you have a question about the GAS3400AS and is the answer not in the manual?
Questions and answers